Test interfaces with agent-browser

Use the installed agent-browser CLI for rendered, user-facing verification. Load its version-matched instructions before relying on command syntax:

agent-browser skills get core --full

Use a specialized bundled guide when the target requires one. agent-browser skills list shows the available guides.

Verification loop

1. Start or identify the target application and record the exact URL and viewport.
2. Open the page in a named session.
3. Take an accessibility snapshot and identify controls by role, label, or snapshot reference.
4. Perform the user action.
5. Wait for the resulting state, then take a fresh snapshot. References can become stale after navigation or a substantial DOM update.
6. Verify the observable result, console errors, and relevant network behavior.
7. Capture screenshots when visual evidence helps establish the result.

For EmDash admin testing, authenticate through the development bypass rather than attempting to automate passkeys:

agent-browser open 'http://localhost:4321/_emdash/api/setup/dev-bypass?redirect=/_emdash/admin'

Use auth/dev-bypass instead when setup is already complete.

Interaction guidance

• Prefer role and label locators when they express the user-facing control clearly. Use snapshot references for efficient exploration.
• Re-snapshot after a dialog opens, a route changes, or content is replaced.
• Wait for a selector or visible state instead of adding a fixed delay unless timing itself is under test.
• Use a named session for flows that depend on cookies or storage. Close sessions that are no longer needed.
• Check agent-browser console and agent-browser errors when the UI behaves unexpectedly.
• Use agent-browser network requests when the result depends on a request or response boundary.

Evidence